Nordvpn dd wrt7/29/2023 One thing I did try was adding this to my startup script right before the flush, as I thought the entry might have been forcing everything to go through tun1: ip route del 0.0.0.0/1 table main These are the results of running ip rule show 0: from all lookup local The variables tun_name and tun_addr resolve to tun1 and 10.8.8.247 respectively. ![]() ![]() Ip route add default via $tun_addr dev $tun_name table 200 These are the commands I run at startup (45 seconds seems to be more than enough time for the VPN to connect successfully): sleep 45 The VPN is NordVPN, and the connection instructions I followed are here: with one difference-I kept my DNS at 8.8.8.8 and 8.8.4.4 rather than Nord's DNS. The instructions I've been following are from here: (VAP) The article notes the author was unsuccessful in getting this to work past a certain build, but their error message was related to TLS auth, which I don't think is relevant here. ![]() However, all traffic seems to go through the VPN, not just traffic from the 192.168.2.0 subnet, as I'd intended. In my case specifically, the subnet (either 192.168.0.0 or 2.0) is assigned based on the SSID a device is connected to, and that part seems to work fine. ![]() I'm trying to set up my DD-WRT router so that it directs traffic either through my VPN, or directly through my ISP, depending on the subnet of the requesting machine.
0 Comments
Leave a Reply. |